Skip to main content Skip to search Skip to main navigation

  Expert advice

  Fast delivery

  +49 7151 903950

  Support: Mon-Fri 8am-5pm

Product information "232A0440 ToolReg pressure regulator"

In-Line pressure regulator with factory-set outlet pressure, reducing from e.g. 15 bar to 6 bar. With an outlet pressure tolerance of only ±10% *2 it is especially suitable for nailing machines.

Select the pressure regulator according to the desired outlet pressure. The outlet pressure cannot be subsequently adjusted. This safeguards against tampering.
Connection: Female thread G 1/2
Connection description: Female thread G 1/2
Outlet pressure: 4 bar
Seal description: Nitrite-butadiene rubber
Flow rate in l/min: 1800
Weight in kg: 0,075
Hydraulics: No
Material: Aluminium
max. inlet pressure: 25 bar
Medium suitability: compressed air or non-corrosive gases
Surface: blank finish
Pneumatics: Yes
Series: 232
Series long: 232
Working temperature: 0°C up to +80°C
Advantages: • Higher safety through lower pressure. Tools and equipment protected against pressure damages.• Cost reduction through substantially reduced air consumption. Longer service life.• Noise reduction for tools.
Water-resistant: No
Material seal: NBR
Additional information: Relieving at removal of supply pressure.
All information is intended as a non-binding guideline! We do not assume liability for any data selection not confirmed in writing.


232A0420
A mm: 30
Connection A: G 1/2
B mm: 68
SW mm: 27
SW1 mm: 30