Skip to main content Skip to search Skip to main navigation

  Expert advice

  Fast delivery

  +49 7151 903950

  Support: Mon-Fri 8am-5pm

Product information "231A0280 SaveAir pressure regulator"

In-Line pressure regulator with factory-set outlet pressure, reducing from e.g. 15 bar to 5 bar. The regulator is suited for basic pressure control only with an outlet pressure tolerance of approx. ± 10%*2. Non-relieving function, therefore not recommended for applications such as nailers.

Select the pressure regulator according to the desired outlet pressure. The outlet pressure cannot be subsequently adjusted. This safeguards against tampering.
Connection: Female thread G 1/4
Connection description: Female thread G 1/4
Outlet pressure: 8 bar
Seal description: Nitrite-butadiene rubber
Flow rate in l/min: 800
Case: Zinc
Weight in kg: 0,09
Hydraulics: No
Material: Zinc
max. inlet pressure: 18 bar
Medium suitability: compressed air or non-corrosive gases
Surface: blank finish
Pneumatics: Yes
Relieving function: non-relieving
Series: 231
Series long: 231
Working temperature: 0°C up to +60°C
Advantages: • Higher safety through lower pressure. Tools and equipment protected against pressure damages.• Cost reduction through substantially reduced air consumption.• Noise reducing for tools.
Water-resistant: No
Material connection: Zinc
Material seal: NBR
All information is intended as a non-binding guideline! We do not assume liability for any data selection not confirmed in writing.


231A0220
A mm: 34
Connection A: G 1/4
B mm: 52
SW mm: 17