In-Line pressure regulator with factory-set outlet pressure, reducing from e.g. 15 bar to 5 bar. The regulator is suited for basic pressure control only with an outlet pressure tolerance of approx. ± 10%*2. Non-relieving function, therefore not recommended for applications such as nailers.
Select the pressure regulator according to the desired outlet pressure. The outlet pressure cannot be subsequently adjusted. This safeguards against tampering.
Select the pressure regulator according to the desired outlet pressure. The outlet pressure cannot be subsequently adjusted. This safeguards against tampering.
| Series: | 231 |
| Flow rate in l/min: | 800 |
| Series long: | 231 |
| max. inlet pressure: | 18 bar |
| Outlet pressure: | 6 bar |
| Relieving function: | non-relieving |
| Advantages: | • Higher safety through lower pressure. Tools and equipment protected against pressure damages. • Cost reduction through substantially reduced air consumption. • Noise reducing for tools. |
| Working temperature: | 0°C up to +60°C |
| Connection: | Female thread G 1/4 |
| Connection description: | Female thread G 1/4 |
| Material: | Zinc |
| Seal description: | Nitrite-butadiene rubber |
| Surface: | blank finish |
| Material connection: | Zinc |
| Material seal: | NBR |
| Case: | Zinc |
| Medium suitability: | compressed air or non-corrosive gases |
| Weight in kg: | 0,09 |
| Hydraulics: | No |
| Pneumatics: | Yes |
| Water-resistant: | No |
All information is intended as a non-binding guideline! We do not assume liability for any data selection not confirmed in writing.
Available downloads:
3D Modell